Products You May Like

Remington XP/XR 100, Model 7 Short Action Picatinny Rail Scope Mount 0 MOA 4 Holes Ambidextrous $39.99
T/C Contender Picatinny Rail Scope Mount 0 MOA Ambidextrous $29.99
Browning A-Bolt WSSM Picatinny Rail Scope Mount 0 MOA Ambidextrous $39.99
Browning BAR/BLR Long Action Rifle Picatinny Rail Scope Mount Silver Ambidextrous $34.99
Winchester 1300 Picatinny Scope Rail Mount Ambidextrous $29.99
HD Kimber 8400 (8400 WSM) Short Action Picatinny Rail Scope Mount 20 MOA Ambidextrous $69.99
Ruger M-77 Long Action Picatinny Rail Mounts (MUST DRILL & TAP RECEIVER) 20 MOA Ambidextrous
Click to enlarge

Ruger M-77 Long Action Picatinny Rail Mounts (MUST DRILL & TAP RECEIVER) 20 MOA Ambidextrous

Product #: 46122
Price: $39.99

Purchase

No Thanks
Torx Screws Only (+$3.00)
Torx Bit and Screws (+$4.00)
E-mail to a friend

Description

Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black
Mounting Hardware: Hex head screws and wrench provided
Center Spread: 4.215"
Overall Length: 6.670"

This base also fits the Ruger Hawkeye Long Action. 

This mount is sold DRILLED for 8-40 screws and is available in a 0 or 20 MOA and is specifically made to fit the Ruger M77. This mount will require you to drill and tap your receiver.

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards


*The center spread is the distance between the two middle holes, center to center, on your receiver.

This base sits at approximately 0.4” high.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.

Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings. 

Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!

We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

Product Reviews

Login or Register to write the first review.