Products You May Like

AR Bolt Carrier Cleaning Brush and Holder $20.00
Hood Length Gauge $25.00
10-8 Performance Armorer Tool $10.00
Cowboy Chamber Checker (357, 44-40, 44 Mag, .45 Long Colt) $25.00
Ammo Chamber Checker 9 mm 7-hole $20.00
Reverse Plug Cutter HSS $60.00
Undersize Reloading Die, 9mm Luger
Click to enlarge

Undersize Reloading Die, 9mm Luger

Product #: 70010
Price: $29.00


In Stock
E-mail to a friend


Caliber: 9mm
Brand: Lee Precision

Our Dies are maufactured by Lee Precision.

If a die is available online to purchase, it is in stock. Due to high demand the inventory will be fluctuating constantly.

Extra decapping pins available here.

A must for the serious reloader: EGW offers custom designed, carbide sizing dies that are 0.003" smaller in diameter than typical dies. Not only is it smaller in diameter, the bottom corner is radiused which sizes the case further down. This helps prevent feed failures from cases that bulged near the base during reloading- which is typical of brass fired in Glocks and other loose chambered guns.

The dies are made out of carbide.

No lubrication needed. Because the carbide is so hard, no lubrication is required on the case. You will find the die will actually burnish the case and improve its appearance. The die will last a lifetime!

Screw the full length sizer in until it touches the shellholder and tighten the lock ring finger tight. The decapper is retained by a collet. Should it be overstressed by an obstruction, it simply slides up without damage. To reset, loosen the decapper flush with clamp end and retighten. Considerable torque may be necessary. A ½” and ¾” wrench are required.

Undersized Reloading Dies will work with a Dillon Press if they are 550, 650, or 1050. They will not work if they are squared.

Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to

Product Reviews

Login or Register to write a review.
Reviewed by bought "Undersize Reloading Die, 9mm Luger" on our website
08/24/2017 - 10:01:21 PM
Alpha Wolf Barrel for G43
Purchased an Alpha Wolf (AW) barrel from Lone Wolf and quickly realized my factory Lee resizing die wouldn't resize far enough to work with the tight tolerance of the AW barrel. Most 'advice' in the forums discussed reaming the barrel or shooting a few hundred +P rounds for a break in. Purchased the 9mm undersized die from EGW, dialed it in, just a touch crimp...and all loads gauge perfectly in the AW barrel. Shot my first 50 off the press with not one issue. For $30 problem solved...and the ammo is now even better than from a regular Lee die.
Reviewed by snakelady
snakelady bought "Undersize Reloading Die, 9mm Luger" on our website
01/21/2016 - 01:45:25 AM
9 mm Undersize die
This die was recommended to me and I am that happy I purchased this product Out of 800 9 mm used shells there were 10 that I couldn`t resize . Very glad I got this One one hiccup I have a Dillon 650 and when I seated the die I ran out of thread to tighten the lock nut but it didnt make much difference