Machined From: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Only
Mounting Hardware: #8-40 X 1/4 Screws and T-10 Bit Included
Center Spread: 0.787"
Overall Length of Mount: 6.276"
Rearmost Screw to Breech: .57" (if your CVA measures 1.29" here you have a regular CVA and will need to use the other mount made specifically for that gun)
Distance from Rearmost Screw to Breech - .57"
Please check this distance before ordering!
There have been some issues with the newer model CVAs where the screw mounting holes are too far back. Please check to make sure your rearmost screw hole is approximately .57" from the breech.
If your CVA Rifle is 2010 and newer please choose our CENTERFIRE mount.If your muzzle loader is 2009 or older, please choose our MUZZLE LOADER mount.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
This base sits at approximately 0.4” high.
This mount also fits:
Bergara B13Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW’s Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
Write Your Own Review