Machined From: Domestic 7075 T6 Extruded Aluminum
Finish: Hardcoat Anodized Matte Black
Mounting Hardware:#6-48 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs
Center Spread: 3.19"
Overall Length: 5.488"
Standard vs. HD rails
This mount fits:
Browning BAR (all calibers)
Browning BLR Long Action
Browning Short Trac
Benelli R1 (see below)
Browning BLR Takedown*
*This mount will only work with the BLR Takedown if the modification option has been selected above.
This mount will fit the Benelli R1 Rifles. It will cover the middle hole on their action, but will use the front and back pairs.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW? one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Add EGW? Practical or HD Scope Rings to make it a complete overhaul!
We machine these in our shop using one of our USA-made Fadal machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc.
For more information, go to www.P65Warnings.ca.gov.