Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: Undrilled
Overall Length: 6.670"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
More Information Minute Of Angle (MOA) 20 MOA Firearm Brand FNH, Herters, Husqvarna, Interarms, J. C. Higgins, Mauser, Parker Hale, Remington, Ruger, Santa Barbara, Zastava Model Early Model 77 (Commercial Mauser), J9, Large Ring Commercial (98), M70 Mauser, Mark X (Commercial Mauser), Model 50, 51, 51-L, Model 798 (Commercial Mauser), Model 1200, Model 5000, XK3 Scope Mount Color Black Anodized Type II GTIN 841370106820
Write Your Own Review
Great mountThis mount has worked great so far. The rifle is a K98k that was a Yugo capture rifle so all the original markings were scrubbed. I picked it for it’s exceptional bore. I was hoping to achieve 1 MOA groups with this set up. I bedded the action, shimmed the bore and polished the sear/trigger. Much to my amazement I have shot multiple sub .25 MOA groups with this set up at 100 yards. I too it out to 1033 yards two days ago and shot 4 shots into a 2.125” group, so about .206 MOA. This is much better than I had hoped for. I’d put some photos up but it won’t seem to allow me to do so.