FREE U.S. SHIPPING on orders over $80
  • Product Details
    Material:7075 Aluminum
    Coating:Matte Black Hardcoat
    Overall Length:1.604"
    Overall Width:.99"
    Mounting Hardware:(2) 6-32 Button Head Screws, (1) 6-48 Hex Head Screw
    Red Dot Fitment:Leupold DeltaPoint Pro, JPoint, Shield RMS/RMSc/SMS, Redfield Accelerator, Optima

    Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

    Our mount will fit K, L, N, and X frames.

    If your revolver is not drilled and tapped this mount will not work. The best way to verify that it is/is not drilled and tapped is to open the cylinder and check the rib underneath. There should be through holes that are drilled and tapped. If there are not (like the above images) this mount will not work without you having the gun drilled and tapped.

    If your top strap is not already drilled and tapped (pictured above), our mount will not work with your gun. You can have a competent and qualified gunsmith drill and tap the top strap with the standard S&W hole pattern which will allow you to use our mount.


    Installation Instructions
    - Remove the rear sight*
    - Install the EGW Sight Mount in the dovetail
    - Tighten set screw (if applicable)
    - Place the red dot sight on the EGW Sight Mount
    (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
    - Apply blue Loctite to the provided mounting screws
    - Torque mounting screws to 15in/lbs
  • Reviews
    Write Your Own Review
    You're reviewing:DeltaPoint Pro S&W Revolver Sight Mount (fits Shield RMS/RMSc/SMS, JPoint, Redfield Accelerator, and Optima)