Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Silver Anodized
Mounting Hardware: #6-48 X 1/4T-10 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs
Center Spread: 3.930"
Overall Length: 6.670"
Due to the change in which receivers have #6 and #8 screws from Savage, we recommend you remove and measure one of the screws prior to purchasing our scope mount. This will ensure that you receive the correct screws necessary for your specific application. Our scope mount can be drilled to accommodate #8 screws for an additional $10. We also have a#8 Drill Out Kitavailable for customers looking to drill the mounts out themselves. If you have questions about your specific firearm, or need help regarding the specific screw size, you should contact Savage Customer Support at(413) 568-7001 or (800) 370-0708 and supply them with your serial number.
Rifles requiring #8 screws (please check your individual rifle to be sure):
10/110 BA Stealth
10/110 Stealth Evolution
110 Tactical LH
110 Tactical Desert
Christensen Arms Ridgeline (Please Check Your Serial Number Here)
#6 Screws - .13" diameter
#8 Screws - .16" diameter
This Savage base will work with any short action round back Savage rifle with an ejection port.
The round back on this mount will accommodate rounded receivers, and guns that have an accu-trigger. Savages without an accu-trigger will require our flat back mount (listed separately).
The middle spread is the distance between the two middle holes, center to center, on your receiver.
This mount is available in 0 or 20 MOA.
0 MOA -if shooting 0-500 yards
20 MOA -if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Please see our FAQ pages for more information on action lengths and MOA.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories.
The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average.
Also, in many cases, it will not obstruct usage of factory iron sights.
EGW's one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
Add EGW's Practical or HD Scope Rings to make it a complete overhaul!
Available in matte black or silver-anodized.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
Write Your Own Review