Machined From:4140 Carbon Steel
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware:#6-48 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs
Overall Length of Mount:6.670"
Standard vs. HD rails
Due to the change in which receivers have #6 and #8 screws from Savage, we recommend you remove and measure one of the screws prior to purchasing our scope mount. This will ensure that you receive the correct screws necessary for your specific application. Our scope mount can be drilled to accommodate #8 screws for an additional $10. We also have a#8 Drill Out Kitavailable for customers looking to drill the mounts out themselves. If you have questions about your specific firearm, or need help regarding the specific screw size, you should contact Savage Customer Support at(413) 568-7001 or (800) 370-0708 and supply them with your serial number.
Rifles requiring #8 screws (please check your individual rifle to be sure):
10/110 BA Stealth
10/110 Stealth Evolution
110 Tactical LH
110 Tactical Desert
Christensen Arms Ridgeline (Please Check Your Serial Number Here)
#6 Screws - .13" diameter
#8 Screws - .16" diameter
Our HD Savage bases will work with any short action round back Savage rifle.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
These bases sit at approximately 0.35?high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
0 MOA -if shooting 0-500 yards
20 MOA -if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Compatible with Picatinny or Weaver scope rings. Add EGW? HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW? products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
After machining; the mounts are sand blasted. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc.
For more information, go to www.P65Warnings.ca.gov.