Steel HD Savage Short Action Round Back Picatinny Rail 20 MOA

Due to the change in which receivers have #6 and #8 screws from Savage, we recommend you remove and measure one of the screws prior to purchasing our scope mount. This will ensure that you receive the correct screws necessary for your specific application. Some Savage guns (like the .338 Lapua or 110 BA) require 8-40 screws. We now have mounts drilled for #8 screws available for all MOAs. We also have a #8 Drill Out Kit available for customers who would like to drill the mounts out themselves. If you have questions about your specific firearm, or need help regarding the specific screw size, you should contact Savage Customer Support at (413) 568-7001 or (800) 370-0708 and supply them with your serial number.

This mount is drilled for and provided with 6-48 Hex Head screws.  We recommend reviewing our listing below for predrilled #8 mounts if you require #8 screws. Our 8-40 and 6-48 screws utilize the same head design, which allows us to use the same countersink in all of our mounts. If you purchased a mount with the incorrect screws, you can purchase our #8 Drill Out Kit.

We do offer Savage rails that are pre-drilled for #8 screws. They are available here:
HD Savage Round Back Short Action 0 MOA Drilled for #8-40 Screws
HD Savage Round Back Short Action 20 MOA Drilled for #8-40 Screws
HD Savage Round Back Short Action 30 MOA Drilled for #8-40 Screws
HD Savage Round Back Short Action 40 MOA Drilled for #8-40 Screws

Rifles requiring #8 screws (please check your individual rifle to be sure):
10/110 BA Stealth
10/110 Stealth Evolution
110 Scout
110 Wolverine
10 GRS
110 Tactical
110 Tactical LH
110 Tactical Desert
110 Ridge Warrior
110 Ultralite
Christensen Arms Ridgeline (Please Check Your Serial Number Here)

Screw Diameters
#6 Screws - .13" diameter
#8 Screws - .16" diameter

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and parkerized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.