Material:7075 AluminumCoating:Matte Black HardcoatOverall Length:1.831"Overall Width:1.062"Mounting Hardware:(2) 8-32 Button Head Screws, (1) 6-32 Torx Head Screw)Red Dot Fitment:Vortex Razor, C-More RTS & STS
Simply remove the rear sight on your gun and replace it with our mount in order to mount yourVortex Razor, C-More RTS or STSred-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Our mount will fit K, L, N, and X frames.
If your revolver is not drilled and tapped this mount will not work. The best way to verify that it is/is not drilled and tapped is to open the cylinder and check the rib underneath. There should be through holes that are drilled and tapped. If there are not (like the above images) this mount will not work without you having the gun drilled and tapped.
If your top strap is not already drilled and tapped (pictured above), our mount will not work with your gun. You can have a competent and qualified gunsmith drill and tap the top strap with the standard S&W hole pattern which will allow you to use our mount.
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
The screws that are included with this mount require a 5/64'' allen wrench for installation.
Click here to see a video from Vortex on how to install our red dot base on a slide.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc.
For more information, go to www.P65Warnings.ca.gov.